| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In Eclipse ThreadX NetX Duo versions up to and including 6.5.2.202603, the SNMP agent's OID parser uses a multi-byte BER length from the request without checking it against the bytes present, and reads past the end of the packet buffer. A remote, unauthenticated attacker can send a crafted SNMP request that makes the agent read adjacent memory into its OID state, faulting the agent on targets with memory protection. |
| In Eclipse ThreadX NetX Duo versions up to and including 6.5.2.202603, built with IPv6, the ICMPv6 option validator accepts an option area that ends in a one- or two-byte residue, and the Router Advertisement, Neighbor Solicitation, Neighbor Advertisement and Redirect handlers then walk it without length checks. A host on the local link can send one such message to make the IP thread read past the packet or loop forever, and can place off-packet memory in the neighbor cache. |
| In Eclipse ThreadX NetX Duo versions up to and including 6.5.2.202603, built with packet chaining, the TFTP server does not bound the length of a received DATA datagram. An unauthenticated peer can upload an oversized datagram that writes memory beyond the received packet into the file and read it back by downloading the file, and the same datagram can suspend the server thread permanently. |
| In Eclipse ThreadX NetX Duo versions up to and including 6.5.2.202603, built with DTLS server support, the NetX Secure DTLS server's ClientHello parser reads the session ID, cookie and ciphersuite list without bounding them by the bytes remaining in the message. An unauthenticated peer can send a ClientHello declaring fields longer than the message and make the server read past it; nothing read is sent back to the peer, and the read can fault the server only on targets that trap the address beyond the buffer. |
| In Eclipse ThreadX NetX Duo versions 6.0 through 6.5.2.202603a, the NetX Secure TLS client's ServerHello parser and DTLS client's HelloVerifyRequest parser read fields before checking that the message is long enough to contain them. A malicious server or an on-path attacker can make the client read up to three bytes past a handshake message, which can fault the client on targets with memory protection. |
| In Eclipse ThreadX NetX Duo versions 6.0 through 6.5.2.202603a, the PPP IPCP code parses a peer's Configure-Nak without validating each option's length. A malicious PPP peer can stall the PPP thread indefinitely with a zero-length option, taking the link down, and can read back up to four bytes of packet-buffer memory per exchange with a short address option. |
| In Eclipse ThreadX NetX Duo versions 6.4.0 through 6.5.2.202603a, built with VLAN and SRP support, the MSRP parser uses the attribute list length from the received frame without comparing it with the packet length. An unauthenticated station on the same Layer 2 segment can send a short MSRP frame declaring a long list and make the MRP worker read far past the received packet, faulting it on targets with memory protection. |
| In Eclipse ThreadX NetX Duo versions 6.0 through 6.5.2.202603a, the TFTP client copies the message of a received ERROR packet without bounding the copy by the end of the datagram, and the TFTP server reads one byte past a minimal ERROR packet. A malicious TFTP server can make the client copy up to 64 bytes of adjacent packet-pool memory into the error string the application retrieves, or fault on targets with memory protection. |
| CSV formula injection vulnerability in the export functionality of the Coupa Supplier Portal SaaS platform. The vulnerability arises because certain user-controlled data, such as event names or templates within the Tenders module, are not properly validated or sanitised before being included in CSV files generated by the application. An attacker with low privileges can input specially crafted values that begin with characters interpreted as formulas by spreadsheet applications. When a victim downloads and opens the generated file in a compatible client, the content may be interpreted as a formula, potentially leading to unauthorised actions such as the execution of commands via mechanisms such as DDE, access to information, or interaction with system resources under the victim’s context. |
| In Eclipse ThreadX NetX Duo versions 6.0 through 6.5.2.202603a, the DHCP client's option walk advances its offset one byte less than its read pointer for every option it skips. A DHCP server, or any host on the link that answers first, can make the client read up to about a kilobyte past the received message, and the same walk copies out-of-bounds bytes into the application's buffer when it retrieves a user option. |
| In Eclipse ThreadX versions 6.0.1 through 6.5.2.202603, the Module Manager loaders take a module image without its length and trust the sizes and offsets in its preamble. A crafted module image can declare a code size larger than the image to read, or gain access to, the memory that follows it, and can place its entry points outside its code. |
| Zephyr's Precision Time Protocol receive handler ptp_msg_post_recv() in subsys/net/lib/ptp/msg.c takes the 4-bit message type straight off the wire via ptp_msg_type() (msg->header.type_major_sdo_id & 0xF, range 0-15) and uses it to index the msg_size[] table. That table only defines entries up to PTP_MSG_MANAGEMENT (0xD), giving it ARRAY_SIZE == 14. Before the fix there was no upper-bound check, so the undefined types 0xE and 0xF indexed one or two int slots past the end of the array — an out-of-bounds read of adjacent read-only data.
The out-of-bounds value is then reused as a length: it gates msg_size[type] > cnt, and when it is small or negative it makes cnt - msg_size[type] a large positive budget passed to msg_tlv_post_recv(), whose TLV loop then walks the message suffix past the received bytes, performing further out-of-bounds reads and in-place byte-swap writes on memory beyond the message slab.
The defect is reached directly from the network: ptp_port_event_gen() in subsys/net/lib/ptp/port.c reads a PTP frame with ptp_transport_recv() and calls ptp_msg_post_recv() with the attacker-chosen type. PTP uses UDP multicast or raw Ethernet (0x88F7) and is unauthenticated, so any host on the same link can trigger the indexing on a CONFIG_PTP-enabled node with no preconditions.
The reliably reproducible impact is a denial of service (fault/crash); a limited memory-corruption path exists but depends on the build-specific value adjacent to msg_size[], which the attacker cannot tune. The fix rejects type >= ARRAY_SIZE(msg_size) with -EBADMSG before any indexing. |
| Out of bounds read in ANGLE in Google Chrome on on Mac prior to 157.0.8103.38 allowed a remote attacker to read memory outside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| Buffer Overflow vulnerability in Proftpd commit 4017eff8 allows a remote attacker to execute arbitrary code and can cause a Denial of Service (DoS) on the FTP service by sending a maliciously crafted message to the ProFTPD service port. |
| Out of bounds read in Skia in Google Chrome prior to 157.0.8103.38 allowed a remote attacker to read memory outside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| OpenWrt Project is a Linux operating system targeting embedded devices. In versions prior to 24.10.6 and 25.12.1, the mdns daemon has a Stack-based Buffer Overflow vulnerability in the match_ipv6_addresses function, triggered when processing PTR queries for IPv6 reverse DNS domains (.ip6.arpa) received via multicast DNS on UDP port 5353. During processing, the domain name from name_buffer is copied via strcpy into a fixed 256-byte stack buffer, and then the reverse IPv6 request is extracted into a buffer of only 46 bytes (INET6_ADDRSTRLEN). Because the length of the data is never validated before this extraction, an attacker can supply input larger than 46 bytes, causing an out-of-bounds write. This allows a specially crafted DNS query to overflow the stack buffer in match_ipv6_addresses, potentially enabling remote code execution. This issue has been fixed in versions 24.10.6 and 25.12.1. |
| OpenWrt Project is a Linux operating system targeting embedded devices. In versions prior to 24.10.6 and 25.12.1, the mdns daemon has a Stack-based Buffer Overflow vulnerability in the parse_question function. The issue is triggered by PTR queries for reverse DNS domains (.in-addr.arpa and .ip6.arpa). DNS packets received on UDP port 5353 are expanded by dn_expand into an 8096-byte global buffer (name_buffer), which is then copied via an unbounded strcpy into a fixed 256-byte stack buffer when handling TYPE_PTR queries. The overflow is possible because dn_expand converts non-printable ASCII bytes (e.g., 0x01) into multi-character octal representations (e.g., \001), significantly inflating the expanded name beyond the stack buffer's capacity. A crafted DNS packet can exploit this expansion behavior to overflow the stack buffer, making the vulnerability reachable through normal multicast DNS packet processing. This issue has been fixed in versions 24.10.6 and 25.12.1. |
| Out of bounds read in Animation in Google Chrome prior to 157.0.8103.38 allowed a remote attacker to potentially read memory inside the sandbox via a crafted HTML page. (Chromium security severity: Low) |
| Out of bounds read in Skia in Google Chrome prior to 157.0.8103.38 allowed a remote attacker to read memory outside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| Incorrect authorization in FileSystem in Google Chrome prior to 156.0.8078.79 allowed a remote attacker leveraging social engineering to obtain sensitive information via a crafted HTML page. (Chromium security severity: Medium) |
