| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| MONAI (Medical Open Network for AI) is an AI toolkit for health care imaging. Prior to 1.6.1, PydicomReader._get_affine() trusts non-finite values in the DICOM PixelSpacing, ImagePositionPatient, and ImageOrientationPatient fields and composes them into an affine matrix without validation. An unauthenticated attacker who can upload a crafted DICOM to a default MONAILabel deployment can propagate NaN or infinity values through LoadImaged, Spacingd, model inference, and output writing, causing inference failures, persistent datastore poisoning, or geometrically corrupted results. This issue is fixed in version 1.6.1. |
| A flaw was found in gix-date. The `gix_date::parse::TimeBuf::as_str` function can generate strings containing invalid non-UTF8 characters. This issue violates the internal safety invariants of the `TimeBuf` component, leading to undefined behavior when these malformed strings are subsequently processed. This could potentially result in application instability or other unforeseen consequences. |
| A flaw was found in libssh versions built with OpenSSL versions older than 3.0, specifically in the ssh_kdf() function responsible for key derivation. Due to inconsistent interpretation of return values where OpenSSL uses 0 to indicate failure and libssh uses 0 for success—the function may mistakenly return a success status even when key derivation fails. This results in uninitialized cryptographic key buffers being used in subsequent communication, potentially compromising SSH sessions' confidentiality, integrity, and availability. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_tables: fix dst corruption in same register operation
For lshift and rshift, the shift operations are performed in a loop over
32-bit words. The loop calculates the shifted value and write it to dst,
and then immediately reads from src to calculate the carry for the next
iteration. Because src and dst could point to the same memory location,
the carry is incorrectly calculated using the newly modified dst value
instead of the original src value.
Adding a temporary local variable to cache the original value before
writing to dst and using it for the carry calculation solves the
problem. In addition, partial overlap is rejected from control plane for
all kind of operations including byteorder. This was tested with the
following bytecode:
table test_table ip flags 0 use 1 handle 1
ip test_table test_chain use 3 type filter hook input prio 0 policy accept packets 0 bytes 0 flags 1
ip test_table test_chain 2
[ immediate reg 1 0x44332211 0x88776655 ]
[ bitwise reg 1 = ( reg 1 << 0x08000000 ) ]
[ cmp eq reg 1 0x66443322 0x00887766 ]
[ counter pkts 0 bytes 0 ]
ip test_table test_chain 4 3
[ immediate reg 1 0x44332211 0x88776655 ]
[ bitwise reg 1 = ( reg 1 << 0x08000000 ) ]
[ cmp eq reg 1 0x55443322 0x00887766 ]
[ counter pkts 21794 bytes 1917798 ] |
| Netty netty-tcnative before 2.0.84.Final contains a denial of service vulnerability in the tcn_write_to_bytebuffer BIO write callback that overreports bytes consumed. Remote TLS 1.3 peers can provoke queued post-handshake records like NewSessionTicket or KeyUpdate to truncate flights, fail connections, or abort the JVM process. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: scope session state changes to bound connections
ksmbd_all_conn_set_status() treats every connection whose transient
binding flag is set as belonging to the target SessionId. A logoff or
session replacement can consequently move an unrelated connection to
NEED_RECONNECT or NEED_SETUP.
Pass the target session itself and select connections using either the
connection-local session xarray or the session's permanent channel list.
Use the same association test while waiting for requests to drain.
Serialize session-wide status changes under request_lock and do not
overwrite EXITING or RELEASING. Protect the shutdown transition with the
same lock so a concurrent session update cannot revive a closing
connection. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing/probes: Remove WARN_ON_ONCE from parse_btf_arg
Sashiko found that user can cause this WARN_ON_ONCE() easily
with adding a kprobe event based on a raw address with BTF
parameter.
Since this is not an unexpected condition, remove the
WARN_ON_ONCE(). |
| In the Linux kernel, the following vulnerability has been resolved:
dm-integrity: don't increment hash_offset twice
hash_offset is already incremented in the loop "for (i = 0; i < to_copy;
i++, ts--)". Do not increment it again. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_u32: reject invalid shift counts
u32_match_it() executes rule-supplied shift operands on a 32-bit
value. A malformed u32 rule can provide a shift count of 32 or more,
triggering an undefined shift out-of-bounds during packet evaluation.
Validate XT_U32_LEFTSH and XT_U32_RIGHTSH operands in
u32_mt_checkentry() and reject malformed rules before they reach the
packet path. |
| Lib/ipaddress.py in Python through 3.8.3 improperly computes hash values in the IPv4Interface and IPv6Interface classes, which might allow a remote attacker to cause a denial of service if an application is affected by the performance of a dictionary containing IPv4Interface or IPv6Interface objects, and this attacker can cause many dictionary entries to be created. This is fixed in: v3.5.10, v3.5.10rc1; v3.6.12; v3.7.9; v3.8.4, v3.8.4rc1, v3.8.5, v3.8.6, v3.8.6rc1; v3.9.0, v3.9.0b4, v3.9.0b5, v3.9.0rc1, v3.9.0rc2. |
| Buffer overflow in libxml2 allows remote attackers to execute arbitrary code by leveraging an incorrect limit for port values when handling redirects. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: chemical: sgp30: Handle IAQ thread creation failure
kthread_run() can fail and return an error pointer, but sgp_probe() stores
it and returns success, so the device is registered without its IAQ thread
and sgp_remove() later passes the error pointer to kthread_stop(). Return
the error from probe instead. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: nVMX: Always flush vpid02 on first use
Make sure vpid02 is always flushed on first use by setting last_vpid=0
when allocating vpid02. nested_vmx_transition_tlb_flush() will always
detect a VPID change on first VM-Enter after VMXON, because VPID=0 in
vmcs12 is not allowed if L1 enables VPID.
This avoids using stale TLB entries from a previous lifetime of the
VPID, that might have been associated with a different vCPU (or a
completely different VM).
Note that last_vpid is already being initialized as 0 when the vCPU is
created, but it is not reset when vpid02 is freed on VMXOFF. Hence, the
problem can only occur if L1 does VMXOFF -> VMXON, runs an L2, and KVM
happens to reuse a VPID that has TLB entries on the physical CPU. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: host: max3421: Fix shift-out-of-bounds in max3421_hub_control()
The `max3421_hub_control()` function handles USB hub class requests
to the virtual root hub. In the `default` branches of both the
`ClearPortFeature` and `SetPortFeature` switch statements, it modifies
`max3421_hcd->port_status` by left shifting 1 by the request's `value`
parameter. However, it does not validate whether this shift will exceed
the width of `port_status`.
So if a malicious userspace task with access to the root hub via
/dev/bus/usb/.../001 issues a USBDEVFS_CONTROL ioctl with `wValue`
greater than or equal to 32, the left shift operation invokes
shift-out-of-bounds undefined behavior. This results in arbitrary
bit corruption of `port_status`, including the normally-immutable
change bits, which can bypass internal state checks and confuse the
hub status.
Fix this by rejecting requests whose `value` exceeds the shift width
before performing the shift.
This issue was found using a KLEE-based symbolic execution tool for
kernel drivers that I'm currently developing. |
| The resend_bytes function in roaming_common.c in the client in OpenSSH 5.x, 6.x, and 7.x before 7.1p2 allows remote servers to obtain sensitive information from process memory by requesting transmission of an entire buffer, as demonstrated by reading a private key. |
| drivers/net/r8169.c in the r8169 driver in the Linux kernel 2.6.32.3 and earlier does not properly check the size of an Ethernet frame that exceeds the MTU, which allows remote attackers to (1) cause a denial of service (temporary network outage) via a packet with a crafted size, in conjunction with certain packets containing A characters and certain packets containing E characters; or (2) cause a denial of service (system crash) via a packet with a crafted size, in conjunction with certain packets containing '\0' characters, related to the value of the status register and erroneous behavior associated with the RxMaxSize register. NOTE: this vulnerability exists because of an incorrect fix for CVE-2009-1389. |
| In AMD Versal Adaptive SoC devices, the incorrect configuration of the SSS during runtime (post-boot) cryptographic operations could cause data to be incorrectly written to and read from invalid locations as well as returning incorrect cryptographic data. |
| A flaw in DRBG number generation within the Network Security Services (NSS) library where the internal state V does not correctly carry bits over. The NSS library has been updated to fix this issue to address this issue and Firefox ESR 52.1 has been updated with NSS version 3.28.4. This vulnerability affects Thunderbird < 52.1, Firefox ESR < 45.9, Firefox ESR < 52.1, and Firefox < 53. |
| pytorch v2.8.0 was discovered to display unexpected behavior when the components torch.rot90 and torch.randn_like are used together. |
| In the Bouncy Castle JCE Provider versions 1.51 to 1.55, a carry propagation bug was introduced in the implementation of squaring for several raw math classes have been fixed (org.bouncycastle.math.raw.Nat???). These classes are used by our custom elliptic curve implementations (org.bouncycastle.math.ec.custom.**), so there was the possibility of rare (in general usage) spurious calculations for elliptic curve scalar multiplications. Such errors would have been detected with high probability by the output validation for our scalar multipliers. |
