Search
Search Results (2 CVEs found)
| CVE | Vendors | Products | Updated | CVSS v3.1 |
|---|---|---|---|---|
| CVE-2026-68129 | 1 Linux | 1 Linux Kernel | 2026-10-19 | 7.5 High |
| In the Linux kernel, the following vulnerability has been resolved: gve: fix Rx queue stall on alloc failure When the system is under extreme memory pressure, page allocations can fail during the Rx buffer refill loop. If the number of buffers posted to hardware falls below a critical low threshold and the refill loop exits due to allocation failures, the queue can stall: 1. The device drops incoming packets because there are no descriptors. 2. Since no packets are processed, no Rx completions are generated. 3. Because no completions occur, NAPI is never scheduled, preventing the refill loop from running again even after memory is freed. This results in a permanent queue stall. Resolve this by introducing a starvation recovery timer for each Rx queue. If the number of buffers posted to hardware falls below a critical low threshold, start a timer to periodically reschedule NAPI. Once NAPI runs and successfully refills the queue above the threshold, the timer is not rescheduled. The threshold is set to 32 because a single maximum-sized Receive Segment Coalescing (RSC) packet can consume up to 19 descriptors in the Rx path. Lower thresholds (such as 8 or 16) would be insufficient to process a complete maximum-sized RSC packet, risking packet drops or unexpected hardware behavior under memory pressure. Setting the threshold to 32 guarantees a safe margin to handle at least one full RSC packet. | ||||
| CVE-2026-68395 | 1 Linux | 1 Linux Kernel | 2026-08-19 | 4.1 Medium |
| In the Linux kernel, the following vulnerability has been resolved: ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered sata_dwc_enable_interrupts() is called before platform_get_irq() and ata_host_activate(), leaving the SATA controller's interrupt mask enabled without a registered handler. If a later step fails (irq request, phy init, etc.) or if the controller asserts an interrupt during probe, the irq line may fire with no handler, causing a spurious interrupt storm. Move sata_dwc_enable_interrupts() after ata_host_activate() so that interrupts are only unmasked once the handler is registered and the core is fully initialized. | ||||
Page 1 of 1.