| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| OpenClaw before 2026.4.22 derives loopback MCP owner context from spoofable server-issued bearer tokens in request headers. Non-owner loopback clients can present themselves as owner to bypass owner-gated operations by manipulating the sender-owner header metadata. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_ppe: avoid NULL deref when gmac0 is disabled
If the gmac0 is disabled, the precheck for a valid ingress device will
cause a NULL pointer deref and crash the system. This happens because
eth->netdev[0] will be NULL but the code will directly try to access
netdev_ops.
Instead of just checking for the first net_device, it must be checked if
any of the mtk_eth net_devices is matching the netdev_ops of the ingress
device. |
| In the Linux kernel, the following vulnerability has been resolved:
iommupt: Fix short gather if the unmap goes into a large mapping
unmap has the odd behavior that it can unmap more than requested if the
ending point lands within the middle of a large or contiguous IOPTE.
In this case the gather should flush everything unmapped which can be
larger than what was requested to be unmapped. The gather was only
flushing the range requested to be unmapped, not extending to the extra
range, resulting in a short invalidation if the caller hits this special
condition.
This was found by the new invalidation/gather test I am adding in
preparation for ARMv8. Claude deduced the root cause.
As far as I remember nothing relies on unmapping a large entry, so this is
likely not a triggerable bug. |
| In the Linux kernel, the following vulnerability has been resolved:
sched_ext: Fix is_bpf_migration_disabled() false negative on non-PREEMPT_RCU
Since commit 8e4f0b1ebcf2 ("bpf: use rcu_read_lock_dont_migrate() for
trampoline.c"), the BPF prolog (__bpf_prog_enter) calls migrate_disable()
only when CONFIG_PREEMPT_RCU is enabled, via rcu_read_lock_dont_migrate().
Without CONFIG_PREEMPT_RCU, the prolog never touches migration_disabled,
so migration_disabled == 1 always means the task is truly
migration-disabled regardless of whether it is the current task.
The old unconditional p == current check was a false negative in this
case, potentially allowing a migration-disabled task to be dispatched to
a remote CPU and triggering scx_error in task_can_run_on_remote_rq().
Only apply the p == current disambiguation when CONFIG_PREEMPT_RCU is
enabled, where the ambiguity with the BPF prolog still exists. |
| In the Linux kernel, the following vulnerability has been resolved:
sched_ext: Fix stale direct dispatch state in ddsp_dsq_id
@p->scx.ddsp_dsq_id can be left set (non-SCX_DSQ_INVALID) triggering a
spurious warning in mark_direct_dispatch() when the next wakeup's
ops.select_cpu() calls scx_bpf_dsq_insert(), such as:
WARNING: kernel/sched/ext.c:1273 at scx_dsq_insert_commit+0xcd/0x140
The root cause is that ddsp_dsq_id was only cleared in dispatch_enqueue(),
which is not reached in all paths that consume or cancel a direct dispatch
verdict.
Fix it by clearing it at the right places:
- direct_dispatch(): cache the direct dispatch state in local variables
and clear it before dispatch_enqueue() on the synchronous path. For
the deferred path, the direct dispatch state must remain set until
process_ddsp_deferred_locals() consumes them.
- process_ddsp_deferred_locals(): cache the dispatch state in local
variables and clear it before calling dispatch_to_local_dsq(), which
may migrate the task to another rq.
- do_enqueue_task(): clear the dispatch state on the enqueue path
(local/global/bypass fallbacks), where the direct dispatch verdict is
ignored.
- dequeue_task_scx(): clear the dispatch state after dispatch_dequeue()
to handle both the deferred dispatch cancellation and the holding_cpu
race, covering all cases where a pending direct dispatch is
cancelled.
- scx_disable_task(): clear the direct dispatch state when
transitioning a task out of the current scheduler. Waking tasks may
have had the direct dispatch state set by the outgoing scheduler's
ops.select_cpu() and then been queued on a wake_list via
ttwu_queue_wakelist(), when SCX_OPS_ALLOW_QUEUED_WAKEUP is set. Such
tasks are not on the runqueue and are not iterated by scx_bypass(),
so their direct dispatch state won't be cleared. Without this clear,
any subsequent SCX scheduler that tries to direct dispatch the task
will trigger the WARN_ON_ONCE() in mark_direct_dispatch(). |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: uvc: fix NULL pointer dereference during unbind race
Commit b81ac4395bbe ("usb: gadget: uvc: allow for application to cleanly
shutdown") introduced two stages of synchronization waits totaling 1500ms
in uvc_function_unbind() to prevent several types of kernel panics.
However, this timing-based approach is insufficient during power
management (PM) transitions.
When the PM subsystem starts freezing user space processes, the
wait_event_interruptible_timeout() is aborted early, which allows the
unbind thread to proceed and nullify the gadget pointer
(cdev->gadget = NULL):
[ 814.123447][ T947] configfs-gadget.g1 gadget.0: uvc: uvc_function_unbind()
[ 814.178583][ T3173] PM: suspend entry (deep)
[ 814.192487][ T3173] Freezing user space processes
[ 814.197668][ T947] configfs-gadget.g1 gadget.0: uvc: uvc_function_unbind no clean disconnect, wait for release
When the PM subsystem resumes or aborts the suspend and tasks are
restarted, the V4L2 release path is executed and attempts to access the
already nullified gadget pointer, triggering a kernel panic:
[ 814.292597][ C0] PM: pm_system_irq_wakeup: 479 triggered dhdpcie_host_wake
[ 814.386727][ T3173] Restarting tasks ...
[ 814.403522][ T4558] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000030
[ 814.404021][ T4558] pc : usb_gadget_deactivate+0x14/0xf4
[ 814.404031][ T4558] lr : usb_function_deactivate+0x54/0x94
[ 814.404078][ T4558] Call trace:
[ 814.404080][ T4558] usb_gadget_deactivate+0x14/0xf4
[ 814.404083][ T4558] usb_function_deactivate+0x54/0x94
[ 814.404087][ T4558] uvc_function_disconnect+0x1c/0x5c
[ 814.404092][ T4558] uvc_v4l2_release+0x44/0xac
[ 814.404095][ T4558] v4l2_release+0xcc/0x130
Address the race condition and NULL pointer dereference by:
1. State Synchronization (flag + mutex)
Introduce a 'func_unbound' flag in struct uvc_device. This allows
uvc_function_disconnect() to safely skip accessing the nullified
cdev->gadget pointer. As suggested by Alan Stern, this flag is protected
by a new mutex (uvc->lock) to ensure proper memory ordering and prevent
instruction reordering or speculative loads. This mutex is also used to
protect 'func_connected' for consistent state management.
2. Explicit Synchronization (completion)
Use a completion to synchronize uvc_function_unbind() with the
uvc_vdev_release() callback. This prevents Use-After-Free (UAF) by
ensuring struct uvc_device is freed after all video device resources
are released. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: u_ether: Fix race between gether_disconnect and eth_stop
A race condition between gether_disconnect() and eth_stop() leads to a
NULL pointer dereference. Specifically, if eth_stop() is triggered
concurrently while gether_disconnect() is tearing down the endpoints,
eth_stop() attempts to access the cleared endpoint descriptor, causing
the following NPE:
Unable to handle kernel NULL pointer dereference
Call trace:
__dwc3_gadget_ep_enable+0x60/0x788
dwc3_gadget_ep_enable+0x70/0xe4
usb_ep_enable+0x60/0x15c
eth_stop+0xb8/0x108
Because eth_stop() crashes while holding the dev->lock, the thread
running gether_disconnect() fails to acquire the same lock and spins
forever, resulting in a hardlockup:
Core - Debugging Information for Hardlockup core(7)
Call trace:
queued_spin_lock_slowpath+0x94/0x488
_raw_spin_lock+0x64/0x6c
gether_disconnect+0x19c/0x1e8
ncm_set_alt+0x68/0x1a0
composite_setup+0x6a0/0xc50
The root cause is that the clearing of dev->port_usb in
gether_disconnect() is delayed until the end of the function.
Move the clearing of dev->port_usb to the very beginning of
gether_disconnect() while holding dev->lock. This cuts off the link
immediately, ensuring eth_stop() will see dev->port_usb as NULL and
safely bail out. |
| An OS command injection vulnerability in the dnsmasq module of TP-Link Archer AX53 v1.0 allows an authenticated adjacent attacker to execute arbitrary code when a specially crafted configuration file is processed due to insufficient input validation. Successful exploitation may allow the attacker to modify device configuration, access sensitive information, or further compromise system integrity.
This issue affects AX53 v1.0: before 1.7.1 Build 20260213. |
| An external configuration control vulnerability in the OpenVPN module of TP-Link AX53 v1.0 allows an authenticated adjacent attacker to read arbitrary files when a malicious configuration file is processed. Successful exploitation may allow unauthorized access to arbitrary files on the device, potentially exposing sensitive information.This issue affects AX53 v1.0: before 1.7.1 Build 20260213. |
| An external control of configuration vulnerability in the OpenVPN module of TP-Link AX53 v1.0 allows an authenticated adjacent attacker to read arbitrary file when a malicious configuration file is processed.
Successful
exploitation may allow unauthorized access to arbitrary files on the device,
potentially exposing sensitive information.This issue affects AX53 v1.0: before 1.7.1 Build 20260213. |
| An OS command injection vulnerability in the OpenVPN module
of TP-Link Archer AX53 v1.0 allows an authenticated adjacent attacker to execute system commands when a specially crafted configuration file is processed due to insufficient input validation. Successful exploitation may allow modification of configuration files, disclosure of sensitive information, or further compromise of device integrity.
This issue affects AX53 v1.0: before 1.7.1 Build 20260213. |
| A stack-based buffer overflow in the tmpServer module of TP-Link Archer AX53 v1.0 allows an authenticated adjacent attacker to trigger a segmentation fault and potentially execute arbitrary code via a specially crafted configuration file. Successful exploitation may cause a crash and could allow arbitrary code execution, enabling modification of device state, exposure of sensitive data, or further compromise of device integrity.
This issue affects AX53 v1.0: before 1.7.1 Build 20260213. |
| In the Linux kernel, the following vulnerability has been resolved:
misc: fastrpc: possible double-free of cctx->remote_heap
fastrpc_init_create_static_process() may free cctx->remote_heap on the
err_map path but does not clear the pointer. Later, fastrpc_rpmsg_remove()
frees cctx->remote_heap again if it is non-NULL, which can lead to a
double-free if the INIT_CREATE_STATIC ioctl hits the error path and the rpmsg
device is subsequently removed/unbound.
Clear cctx->remote_heap after freeing it in the error path to prevent the
later cleanup from freeing it again.
This issue was found by an in-house analysis workflow that extracts AST-based
information and runs static checks, with LLM assistance for triage, and was
confirmed by manual code review.
No hardware testing was performed. |
| OpenClaw versions 2026.3.31 before 2026.4.10 contain a privilege escalation vulnerability where heartbeat owner downgrade detection misses local background async exec completion events. Attackers can exploit this by providing untrusted completion content to leave a run in a more privileged context than intended. |
| OpenClaw before 2026.4.10 contains an insufficient environment variable denylist vulnerability in its exec environment policy that allows operator-supplied overrides of high-risk interpreter startup variables including VIMINIT, EXINIT, LUA_INIT, and HOSTALIASES. Attackers can exploit this by manipulating these environment variables to influence downstream execution behavior or network connectivity. |
| OpenClaw before 2026.4.22 contains a server-side request forgery vulnerability in the Zalo plugin's sendPhoto function that fails to validate outbound photo URLs through the SSRF guard. Attackers can bypass SSRF protection by providing malicious photo URLs to the Zalo Bot API, enabling unauthorized access to internal resources. |
| OpenClaw before 2026.4.15 contains an authorization bypass vulnerability in Matrix room control-command authorization that trusts DM pairing-store entries. Attackers with DM-paired sender IDs can execute room control commands without being in configured allowlists by posting in bot rooms, potentially enabling privileged OpenClaw behavior. |
| OpenClaw before 2026.4.10 contains an improper network binding vulnerability in the sandbox browser CDP relay that exposes Chrome DevTools Protocol on 0.0.0.0. Attackers can access the DevTools protocol outside intended local sandbox boundaries by exploiting the overly broad binding configuration. |
| OpenClaw before 2026.4.10 contains an insufficient access control vulnerability in Nostr plugin HTTP profile routes that allows operators with write permissions to persist profile configuration without requiring admin authority. Attackers with operator.write scope can modify Nostr profile settings through unprotected mutation endpoints to gain unauthorized configuration persistence. |
| OpenClaw before 2026.4.15 captures resolved bearer-auth configuration at startup, allowing revoked tokens to remain valid after SecretRef rotation. Gateway HTTP and WebSocket handlers fail to re-resolve authentication per-request, enabling attackers to use rotated-out bearer tokens for unauthorized gateway access. |
