| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/arm-smmu-v3-iommufd: Require exactly one Stream ID for a vDEVICE
arm_vsmmu_vsid_to_sid() maps a guest's vSID to a single physical Stream ID
taken from master->streams[0], assuming a device has exactly one stream. A
device with several streams gets only its first one mapped, so a guest vSID
invalidation cannot reach the others' ATC and IOTLB entries; a device with
none makes master->streams a ZERO_SIZE_PTR, read out of bounds.
Add an arm_vsmmu_vdevice_init() op to reject the vDEVICE with -EOPNOTSUPP
when master->num_streams is not one, rather than mapping it silently. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: reject frames without a transaction header
hidp_recv_ctrl_frame() and hidp_recv_intr_frame() read skb->data[0]
before checking that the L2CAP SDU contains a transaction header. A
connected HIDP peer can send an empty basic-mode SDU and make both paths
use an uninitialized byte from skb tailroom.
KMSAN reports the use in hidp_session_run(), with the uninitialized value
originating in __alloc_skb() through vhci_write(). The control path
produces two reports and the interrupt path produces one.
The byte can also be controlled by a malformed lower-layer packet. If an
HCI ACL packet contains an L2CAP PDU with a declared zero-length payload
followed by an extra 0x15 byte, l2cap_recv_acldata() reduces skb->len to
the declared PDU length before dispatch. The current HIDP path nevertheless
consumes the extra byte as HIDP_TRANS_HID_CONTROL |
HIDP_CTRL_VIRTUAL_CABLE_UNPLUG and terminates the HIDP session. With this
change, the same packet is discarded and a subsequent feature report
request succeeds.
Pull the transaction header with skb_pull_data() and discard frames that
do not contain it. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw89: fix wrong pci_get_drvdata type in AER handlers
rtw89 stores an ieee80211_hw pointer via pci_set_drvdata() at probe
time, but io_error_detected() and io_resume() retrieve it as a
net_device pointer. This causes netif_device_detach/attach to
operate on an ieee80211_hw struct, reading and writing at wrong
offsets. The adjacent io_slot_reset() already does it correctly.
Use ieee80211_stop_queues/wake_queues instead, consistent with
every other queue stop/start path in the driver.
Tested on RTL8852CE by calling the handlers from a test module
before and after the fix. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: fix OOB read from firmware RX descriptor exceeding DMA buffer
In rtw_pci_rx_napi(), new_len is computed as the sum of pkt_len (14-bit
descriptor field, max 16383) and pkt_offset (drv_info_sz + shift, both
firmware-controlled). The result can exceed RTK_PCI_RX_BUF_SIZE (11478),
causing an out-of-bounds read from the pre-allocated DMA buffer when
skb_put_data copies new_len bytes. The USB transport already validates
this (rtw_usb_rx_data_put checks against RTW_USB_MAX_RECVBUF_SZ); the
PCIe path does not.
Add a check that new_len does not exceed the DMA buffer size. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw89: add bounds check on firmware mac_id in link lookup
The mac_id field in RX descriptors is 8 bits wide (0-255), but
assoc_link_on_macid[] has only RTW89_MAX_MAC_ID_NUM (128) entries.
While the driver currently assigns mac_id values below 128, the
descriptor value comes from firmware and is not validated before use
as an array index. Add a defensive bounds check in
rtw89_assoc_link_rcu_dereference() to guard against out-of-range
firmware values. |
| Heap-based buffer overflow in Microsoft Office Excel allows an unauthorized attacker to execute code over a network. |
| Stack-based buffer overflow in Microsoft Office Outlook allows an unauthorized attacker to execute code over a network. |
| Heap-based buffer overflow in Microsoft Office Excel allows an unauthorized attacker to execute code over a network. |
| Integer overflow or wraparound in Windows Raw Image Extension allows an unauthorized attacker to execute code over a network. |
| IBM Planning Analytics 2.0, and 2.1 could allow a remote authenticated attacker to execute arbitrary code due to a stack-based buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Copy WQE to local buffer in non-SRQ receive path
For non-SRQ QPs, the responder reads WQE fields directly from the
shared queue buffer mapped into userspace. This allows a malicious
user to modify fields like num_sge or sge entries while the kernel
is processing the WQE, leading to out-of-bounds reads in
rxe_resp_check_length() and copy_data().
Introduce get_recv_wqe() that validates num_sge and copies the WQE
to a kernel-local buffer before processing, matching the approach
already used for SRQ WQEs in get_srq_wqe(). The srq_wqe buffer is
reused since SRQ and non-SRQ paths are mutually exclusive per QP. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme: fix FDP fdpcidx bounds check
The fdpcidx bounds check sets n = NUMFDPC + 1 but used > instead of >=,
incorrectly accepting fdp_idx when it equals n (i.e. NUMFDPC + 1). |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wcn36xx: fix OOB read from firmware count in PRINT_REG_INFO indication
The firmware-controlled rsp->count field is used as the loop bound for
indexing into the flexible rsp->regs[] array without validation against
the message length. A count exceeding the actual data causes out-of-
bounds reads from the heap-allocated message buffer.
Add a check that count fits within the received message. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: amd: acp-sdw-legacy: Bound DAI link iteration
create_sdw_dailinks() walks soc_dais until it finds an entry with
initialised cleared, but soc_dais is allocated with exactly num_ends
entries. If all entries are initialised, the loop reads past the end of
the array.
This was reported by KASAN:
BUG: KASAN: slab-out-of-bounds in mc_probe+0x26b3/0x2774 [snd_acp_sdw_legacy_mach]
Read of size 1
Pass the allocated entry count to create_sdw_dailinks() and stop before
reading past the array. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: amd: acp-sdw-sof: Bound DAI link iteration
create_sdw_dailinks() walks sof_dais until it finds an entry with
initialised cleared, but sof_dais is allocated with exactly num_ends
entries. If all entries are initialised, the loop reads past the end of
the array.
Pass the allocated entry count to create_sdw_dailinks() and stop before
reading past the array. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: hdac_hdmi: Validate written enum value
hdac_hdmi_set_pin_port_mux() uses the written enum value to index the
texts array before calling snd_soc_dapm_put_enum_double(), which validates
that the value is within the enum item range.
An out-of-range value can therefore make the driver read past the texts
array before the helper rejects the write. Move the lookup after the helper
has accepted the value. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: meson: aiu: Validate written enum values
The AIU HDMI and internal codec mux put callbacks use the written enum
value with snd_soc_enum_item_to_val() before checking whether the value is
valid for the enumeration.
Reject out-of-range values before converting the enum item, matching the
validation already done by the G12A HDMI and internal codec mux controls. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: fsl: fsl_audmix: Validate written enum values
fsl_audmix_put_mix_clk_src() and fsl_audmix_put_out_src()
convert the user-provided enum item with snd_soc_enum_item_to_val()
before checking whether the item is within the enum's item count.
The generic snd_soc_put_enum_double() helper performs that
validation, but these callbacks use the converted value first: the
clock-source path tests it with BIT(), and the output-source path
indexes the prms transition table with it.
Reject out-of-range enum items before converting them. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: tegra: tegra210_ahub: Validate written enum value
tegra_ahub_put_value_enum() reads e->values[item[0]] before
checking whether item[0] is within the enum item range. The existing
check therefore happens too late to prevent an out-of-range read of the
values array.
Move the check before the array access. |
| In the Linux kernel, the following vulnerability has been resolved:
sctp: validate embedded address parameter length
sctp_verify_asconf() and sctp_verify_param() only validate ADD_IP, DEL_IP,
and SET_PRIMARY parameters against a fixed minimum size of sizeof(struct
sctp_addip_param) + sizeof(struct sctp_paramhdr). This ensures the outer
parameter is large enough to contain an embedded address parameter header,
but does not verify that the embedded address parameter's declared length
fits within the bounds of the outer parameter.
Later, sctp_process_param() and sctp_process_asconf_param() extract the
embedded address parameter and pass it to af->from_addr_param(), which uses
the address parameter length to parse the variable-length address payload.
A malformed peer can therefore advertise an embedded address parameter
length that exceeds the remaining bytes in the enclosing parameter.
Validate that addr_param->p.length does not exceed the space available
after the sctp_addip_param header before processing the embedded address
parameter. Reject malformed parameters when the embedded address length
extends beyond the enclosing parameter bounds.
This prevents out-of-bounds reads when parsing malformed parameters carried
in INIT or ASCONF processing paths. |
