| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: fix possible infinite loop in rt6_fill_node()
Sashiko reported this issue [1]. Apply the same fix as
commit f8d8ce1b515a ("ipv6: fix possible infinite loop in fib6_info_uses_dev()").
Writers holding tb6_lock can list_del_rcu(&rt->fib6_siblings)
without waiting for RCU readers; rt->fib6_siblings.next then still
points into the old ring and this softirq-side walker never reaches
&rt->fib6_siblings, causing a CPU stall. fib6_del_route() always
WRITE_ONCE()s rt->fib6_nsiblings to 0 before list_del_rcu(), so an
inside-loop check is a reliable detach signal.
[1] https://sashiko.dev/#/patchset/20260526020227.4857-1-jiayuan.chen%40linux.dev |
| In the Linux kernel, the following vulnerability has been resolved:
tty: serial: samsung: Remove redundant port lock acquisition in rx helpers
Sashiko identified a deadlock when the console flow is engaged [1].
When console flow control is enabled (UPF_CONS_FLOW),
s3c24xx_serial_stop_tx() calls s3c24xx_serial_rx_enable() and
s3c24xx_serial_start_tx() calls s3c24xx_serial_rx_disable().
The serial core framework invokes the .stop_tx() and .start_tx()
callbacks with the port->lock spinlock already held. Furthermore, all
internal driver paths that invoke stop_tx (such as the DMA TX
completion handler s3c24xx_serial_tx_dma_complete() or the PIO TX IRQ
handler s3c24xx_serial_tx_irq()) also acquire port->lock prior to
calling it. (Note that s3c24xx_serial_start_tx() is only invoked by the
serial core).
However, s3c24xx_serial_rx_enable() and s3c24xx_serial_rx_disable()
unconditionally attempt to acquire port->lock again using
uart_port_lock_irqsave(). Since spinlocks are not recursive, this
causes a deadlock on the same CPU when console flow control is engaged.
Remove the redundant lock acquisition from both rx helper functions. |
| In the Linux kernel, the following vulnerability has been resolved:
nvmem: layouts: onie-tlv: fix hang on unknown types
The EEPROM on my board has a vendor specific entry of type 0x41. When
stumbling upon that, this driver hangs in an endless loop.
Fix it by keep incrementing the offset on unknown entries, so the loop
will eventually stop. |
| In the Linux kernel, the following vulnerability has been resolved:
slimbus: qcom-ngd-ctrl: Avoid ABBA on tx_lock/ctrl->lock
During the SSR/PDR down notification the tx_lock is taken with the
intent to provide synchronization with active DMA transfers.
But during this period qcom_slim_ngd_down() is invoked, which ends up in
slim_report_absent(), which takes the slim_controller lock. In multiple
other codepaths these two locks are taken in the opposite order (i.e.
slim_controller then tx_lock).
The result is a lockdep splat, and a possible deadlock:
rprocctl/449 is trying to acquire lock:
ffff00009793e620 (&ctrl->lock){+.+.}-{4:4}, at: slim_report_absent (drivers/slimbus/core.c:322) slimbus
but task is already holding lock:
ffff00009793fb50 (&ctrl->tx_lock){+.+.}-{4:4}, at: qcom_slim_ngd_ssr_pdr_notify (drivers/slimbus/qcom-ngd-ctrl.c:1475) slim_qcom_ngd_ctrl
which lock already depends on the new lock.
Possible unsafe locking scenario:
CPU0 CPU1
---- ----
lock(&ctrl->tx_lock);
lock(&ctrl->lock);
lock(&ctrl->tx_lock);
lock(&ctrl->lock);
The assumption is that the comment refers to the desire to not call
qcom_slim_ngd_exit_dma() while we have an ongoing DMA TX transaction.
But any such transaction is initiated and completed within a single
qcom_slim_ngd_xfer_msg().
Prior to calling qcom_slim_ngd_exit_dma() the slim_controller is torn
down, all child devices are notified that the slimbus is gone and the
child devices are removed.
Stop taking the tx_lock in qcom_slim_ngd_ssr_pdr_notify() to avoid the
deadlock. |
| Improper Input Validation vulnerability in Apache ActiveMQ, Apache ActiveMQ All, Apache ActiveMQ Stomp.
A remote unauthenticated peer that can reach an exposed STOMP connector can trigger denial-of-service behavior by sending a negative content-length. For the NIO STOMP transport, an attacker can keep streaming body bytes and grow the per-connection command buffer beyond configured limits to cause OOM. For the blocking STOMP protocol, an error will instead force abnormal transport exception handling for the affected connection and closure.
This issue affects Apache ActiveMQ: before 5.19.8, from 6.0.0 before 6.2.7; Apache ActiveMQ All: before 5.19.8, from 6.0.0 before 6.2.7; Apache ActiveMQ Stomp: before 5.19.8, from 6.0.0 before 6.2.7.
Users are recommended to upgrade to version 6.2.7 or 5.19.8, which fixes the issue. |
| A vulnerability has been identified in SIMATIC HMI Comfort Outdoor Panels V15 7\" & 15\" (incl. SIPLUS variants) (All versions < V15.1 Update 6), SIMATIC HMI Comfort Outdoor Panels V16 7\" & 15\" (incl. SIPLUS variants) (All versions < V16 Update 4), SIMATIC HMI Comfort Panels V15 4\" - 22\" (incl. SIPLUS variants) (All versions < V15.1 Update 6), SIMATIC HMI Comfort Panels V16 4\" - 22\" (incl. SIPLUS variants) (All versions < V16 Update 4), SIMATIC HMI KTP Mobile Panels V15 KTP400F, KTP700, KTP700F, KTP900 and KTP900F (All versions < V15.1 Update 6), SIMATIC HMI KTP Mobile Panels V16 KTP400F, KTP700, KTP700F, KTP900 and KTP900F (All versions < V16 Update 4), SIMATIC WinCC Runtime Advanced V15 (All versions < V15.1 Update 6), SIMATIC WinCC Runtime Advanced V16 (All versions < V16 Update 4), SINAMICS GH150 (All versions), SINAMICS GL150 (with option X30) (All versions), SINAMICS GM150 (with option X30) (All versions), SINAMICS SH150 (All versions), SINAMICS SL150 (All versions), SINAMICS SM120 (All versions), SINAMICS SM150 (All versions), SINAMICS SM150i (All versions). A remote attacker could send specially crafted packets to SmartVNC device layout handler on client side, which could influence the amount of resources consumed and result in a Denial-of-Service (infinite loop) condition. |
| Apache POI in versions prior to release 3.17 are vulnerable to Denial of Service Attacks: 1) Infinite Loops while parsing crafted WMF, EMF, MSG and macros (POI bugs 61338 and 61294), and 2) Out of Memory Exceptions while parsing crafted DOC, PPT and XLS (POI bugs 52372 and 61295). |
| tinytag is a Python library for reading audio file metadata. Version 2.2.0 allows an attacker who can supply MP3 files for parsing to trigger a non-terminating loop while the library parses an ID3v2 SYLT (synchronized lyrics) frame. In server-side deployments that automatically parse attacker-supplied files, a single 498-byte MP3 can cause the parsing operation to stop making progress and remain busy until the worker or process is terminated. The root cause is that _parse_synced_lyrics assumes _find_string_end_pos always returns a position greater than the current offset. That assumption is false when no string terminator is present in the remaining frame content. This issue has been fixed in version 2.2.1. |
| In libsixel v1.8.2, there is an infinite loop in the function sixel_decode_raw_impl() in the file fromsixel.c, as demonstrated by sixel2png. |
| The stream_reqbody_cl function in mod_proxy_http.c in the mod_proxy module in the Apache HTTP Server before 2.3.3, when a reverse proxy is configured, does not properly handle an amount of streamed data that exceeds the Content-Length value, which allows remote attackers to cause a denial of service (CPU consumption) via crafted requests. |
| smbd in Samba 3.0 before 3.0.37, 3.2 before 3.2.15, 3.3 before 3.3.8, and 3.4 before 3.4.2 allows remote authenticated users to cause a denial of service (infinite loop) via an unanticipated oplock break notification reply packet. |
| The js_dtoa function in Mozilla Firefox 2.x before 2.0.0.1, 1.5.x before 1.5.0.9, Thunderbird before 1.5.0.9, and SeaMonkey before 1.0.7 overwrites memory instead of exiting when the floating point precision is reduced, which allows remote attackers to cause a denial of service via any plugins that reduce the precision. |
| The _LoadBMP function in imlib 1.9.15 and earlier allows context-dependent attackers to cause a denial of service (infinite loop) via a BMP image with a Bits Per Page (BPP) value of 0. |
| The xmlCurrentChar function in libxml2 before 2.6.31 allows context-dependent attackers to cause a denial of service (infinite loop) via XML containing invalid UTF-8 sequences. |
| libxml2 2.7.0 and 2.7.1 does not properly handle "predefined entities definitions" in entities, which allows context-dependent attackers to cause a denial of service (memory consumption and application crash), as demonstrated by use of xmllint on a certain XML document, a different vulnerability than CVE-2003-1564 and CVE-2008-3281. |
| libclamav/untar.c in ClamAV before 0.95 allows remote attackers to cause a denial of service (infinite loop) via a crafted TAR file that causes (1) clamd and (2) clamscan to hang. |
| The regular expression parser in TCL before 8.4.17, as used in PostgreSQL 8.2 before 8.2.6, 8.1 before 8.1.11, 8.0 before 8.0.15, and 7.4 before 7.4.19, allows context-dependent attackers to cause a denial of service (infinite loop) via a crafted regular expression. |
| Array index error in the gdth_read_event function in drivers/scsi/gdth.c in the Linux kernel before 2.6.32-rc8 allows local users to cause a denial of service or possibly gain privileges via a negative event index in an IOCTL request. |
| The read_multipart function in cgi.rb in Ruby before 1.8.5-p2 does not properly detect boundaries in MIME multipart content, which allows remote attackers to cause a denial of service (infinite loop) via crafted HTTP requests, a different issue than CVE-2006-5467. |
| ImageMagick before 6.3.5-9 allows context-dependent attackers to cause a denial of service via a crafted image file that triggers (1) an infinite loop in the ReadDCMImage function, related to ReadBlobByte function calls; or (2) an infinite loop in the ReadXCFImage function, related to ReadBlobMSBLong function calls. |
